Darek
|
Re:Session Startup - 2009/12/08 10:28
Hello,
Please write us your Eclipse and MDT version. Did you manage to update MDT?
I created a session link and had been using it for the past couple weeks. In the past few days a change has occurred and the Session will start but never gets past "Starting" to "Started".
What kind of change occurred? Did the alias definition change?
One of the sympoms of this is that I never get a Magik command prompt.
Are you sure that, after the change, the session enables command-line interface (console)? If the console is disabled the session will not get Started status in MDT. To ensure please run the session with -cli parameter (see Preview section in MDT help).
I've started the same image with emacs and it starts fine.
I suppose you ran the image with different set of parameters. Please check session launcher command line in MDT (see Session Link Editor Launcher page reference in MDT help) and compare it with the one you used in Emacs.
Do you have any ideas as to what the problem could be? I get no unusual error or warning messages from MDT. Below is the output from the log file up when I start the project followed by the log information when I stop the session.
Please send us at support@mdt.net complete log file(s). That will help us investigate the rest of problems.
Best regards,
Dariusz Michura
Project Manager
ASTEC Sp. z o.o.
ul. Piaskowa 14, PL 65-209 Zielona Góra
Tel.: +48 (0)68 32 980 02
Fax: +48 (0)68 32 980 03
support@mdt.net
www.mdt.net
www.astec.net |
FORUM